|
|
|
| Gas Analyzer / Portable Gas Analyzers |
|
| |
| Model
: G4010 |
 |
| |
¡Ü Galvanic cell ¹æ½Ä ÈÞ´ë¿ë »ê¼ÒºÐ¼®±â ¡Ü °¡º±°í ưưÇÑ Àü¿ë ÄÉÀ̽º¶ó ÈÞ´ëÇϱ⠿ëÀÌ
|
|
 |
|
|
| |
 |
| |
Display : Multi digit LCD - character height 12.7mm
Display ranges 1) E type cell- Display range 0.00% to 100.0%. Resolution: 0.1% from 10 to 100%; 0.01% below 10%. 2) N type cell - Display range 0ppm to 50%. Resolution: 0.1% from 10% to 50%; 0.01% from 0.50% to 9.99%;10ppm from 500ppm to 4999ppm; 1ppm from 0ppm to 499ppm Minimum usable reading 100ppm
Analogue outputs 0 to 1 volt. Full scale point continuously variable over the following range: E type cell version: 5% to 100% N type cell version: 50ppm to 50%
Alarms (Visual display only) Two ?each programmable for concentration, function (high, low and off), hysteresis
Stability : Better than 2% of full-scale per month
Cell life : E type - up to 5 years, N type - up to 18 months
Sample connections Inlet and outlet: captive seal compression fittings suitable for 0.25 inch (or 6mm) o/d tube Sample flow Between 100 and 300 ml/min for optimum operation. Max. 1 l/min
Sampling pressure Pump off: Maximum Inlet pressure 3 bar gauge Pump on: Minimum inlet pressure Atmospheric
Sample vent pressure Atmospheric (for quoted accuracy) Cell must not be subjected to rapid pressure changes
Sample temperature : 5 to +40 ¡É (non condensing)
Speed of response : T90 - variable depending on sensor and concentration. Approximately 3s at % levels and 20s at ppm levels. The ppm figure assumes that the sensor is purged down to the ppm concentration of interest.
Ambient temperature : 0 to 40¡É - continuous, -5 to + 55 ¡É - intermittent
Power supply : Nicad rechargeable cell pack. Operating time at least 10 hours with pump off and 6 hours with pump on. The instruments can also be AC powered from 100v to 240v 50/60Hz. When the AC power is applied the battery is also charged. |
| |
|
|
|